(10% GST will be added in the cart for Australian orders only)

The Motorcycle Cruise Control unit is specifically designed for this vehicle.

NOTE: - This cruise control kit is NOT designed for LED brake/tail lights. If your bike is fitted with LED brake/tail lights, either OE (Original Equipment - built in from new) or aftermarket accessory parts, you MUST select the LED brake light modification when ordering your cruise control kit for this bike.

Earlier model F800GT's have conventional brake lights, later models may be fitted with LED brake lights from the factory, although we have not seen one fitted with LED brake lights yet.

The Motorcycle Cruise Control unit is adapted specifically for this vehicle, with a custom made and fully plug and play wiring harness, using genuine connectors and terminals as used by the manufacturer. There is no wire splicing or any other permanent changes made to your bike.

The motorcycle cruise installation instructions and specific cruise manuals and supporting documents can be found here.

Cruise control switch - there are two options to choose from. See the photos at the top of the page:

MCCruise switch: Our proven, fully-featured and weatherproof switch which comes standard with all of our products. Backlit buttons for night use, power (ON-OFF) indicator light and engage indicator light.
New Slim MCCruise switch: Our new fully-featured and weatherproof switch which is a no cost option and is fitted between the bike's switch block and the clutch lever mount. Backlit buttons for night use, power (ON-OFF) indicator light and engage indicator light. The switch is 10mm (3/8") wide, so it may be necessary to slide the clutch lever assembly across to make space to mount the switch on the handlebar. This is not usually an issue on this model. Contact us for installation instructions if you wish to see how it is fitted.

Cruise control wiring harness - there are two options to choose from. See the link for the brochure below for more details and photos:

The Standard Cruise Wiring Harness has a connector for the bike's accessory CAN-BUS plug. If the bike does NOT have an accessory connected to this plug, the plug will be fitted with a 'dummy' or 'termination' plug. The cruise control harness will have a plug to fit the bike's CAN-BUS accessory plug, and the 'dummy' plug is no longer connected.
The Optional CAN-BUS Dongle Patch has two CAN-BUS connectors and is used when the bike's CAN-BUS accessory plug is connected a device such as a tire pressure monitor or alarm system. This patch allows the bike's accessory AND the cruise control harness to be connected to the bike. NOTE: - if an accessory is not fitted, and the bike has a 'dummy' plug and the dummy plug is connected to this patch harness THE CRUISE CONTROL WILL NOT WORK. The dummy plug 'loads' the CAN-BUS circuit and corrupts the signals. If your bike does not have an accessory fitted DO NOT ORDER THE DONGLE PATCH.

Download the Brochure now:

The electronic cruise control unit is shipped worldwide with all parts, parts list and detailed installation instructions for this kit.

If your bike is fitted with (or you plan to fit) LED brake lights or a brake-light modulator, then a modification to the wiring harness is required to make the cruise control work. Please select the LED brake light option before adding your purchase to the Cart.

Download the Parts List now:

BMW BikeCruise

You also Viewed

About

Site

Main Menu

Connect

Join us and get nice things